D-Link NetDefend DFL-CP310 User Manual page 28

Getting to Know Your NetDefend firewall
Label Description
RESET A button used for rebooting the NetDefend firewall or resetting the NetDefend
firewall to its factory defaults. You need to use a pointed object to press this
button.
•
Short press. Reboots the NetDefend firewall
•
Long press (7 seconds). Resets the NetDefend firewall to its factory
default, and resets your firmware to the version that shipped with the
NetDefend firewall. This results in the loss of all security services and
passwords and reverting to the factory default firmware. You will have
to re-configure your NetDefend firewall.
Do not reset the unit without consulting your system administrator.
USB Two USB 2.0 ports used for connecting USB-based printers
RS232 A serial (RS-232) port used for connecting computers in order to access the
NetDefend CLI (Command Line Interface), or for connecting an external dialup
modem
WAN Wide Area Network: An Ethernet port (RJ-45) used for connecting your cable or
xDSL modem, or for connecting a hub when setting up more than one Internet
connection
DMZ/ A dedicated Ethernet port (RJ-45) used to connect a DMZ (Demilitarized Zone)
WAN2 computer or network. Alternatively, can serve as a secondary WAN port , or as a
VLAN trunk.
LAN 1-4 Local Area Network switch: Four Ethernet ports (RJ-45) used for connecting
computers or other network devices
ANT 1/ Antenna connectors, used to connect the supplied wireless antennas
ANT 2
12 D-Link NetDefend firewall User Guide