Ip Igmp Snooping Vlan Static - Cisco ME 3400 Command Reference Manual

Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands

ip igmp snooping vlan static

Use the ip igmp snooping vlan vlan-id static global configuration command to enable Internet Group
Management Protocol (IGMP) snooping and to statically add a Layer 2 port as a member of a multicast
group. Use the no form of this command to remove ports specified as members of a static multicast
group.
Syntax Description vlan-id
ip-address
interface interface-id
Defaults By default, there are no ports statically configures as members of a multicast group.
Command Modes
Global configuration
Command History Release
12.2(25)EX
Usage Guidelines VLAN IDs 1002 to 1005 are reserved for Token Ring and FDDI VLANs and cannot be used in IGMP
snooping.
The configuration is saved in NVRAM.
Examples
This example shows how to statically configure a port as a multicast router port:
Switch(config)# ip igmp snooping vlan 1 mrouter interface gigabitethernet0/2
You can verify your settings by entering the show ip igmp snooping privileged EXEC command.
OL-9640-07
ip igmp snooping vlan vlan-id static ip-address interface interface-id
no ip igmp snooping vlan vlan-id static ip-address interface interface-id
Enable IGMP snooping on the specified VLAN. The range is 1 to 1001 and
1006 to 4094.
Add a Layer 2 port as a member of a multicast group with the specified group
IP address.
Specify the interface of the member port. The keywords have these
meanings:
fastethernet interface number—a Fast Ethernet IEEE 802.3 interface.
•
gigabitethernet interface number—a Gigabit Ethernet IEEE 802.3z
•
interface.
port-channel interface number—a channel interface. The range is 0
•
to 48.
Modification
This command was introduced.
Cisco ME 3400 Ethernet Access Switch Command Reference
ip igmp snooping vlan static
2-171