Cisco ME 3400 Command Reference Manual page 126

ethernet lmi
For information about the ethernet lmi interface configuration command, go to this URL:
Note
http://www.cisco.com/en/US/products/ps6441/products_feature_guide09186a0080690f2d.html#wp116
6797
To enable the switch as an Ethernet LMI CE device, you must enter both the ethernet lmi global and
ethernet lmi ce commands. By default Ethernet LMI is disabled, and, when enabled the switch is in
provider-edge mode unless you also enter the ethernet lmi ce command.
When the switch is configured as an Ethernet LMI CE device, these interface configuration commands
and keywords are visible, but not supported:
•
•
•
Examples This example shows how to configure the switch as an Ethernet LMI CE device:
Switch(config)# ethernet lmi global
Switch(config)# ethernet lmi ce
Related Commands Command
ethernet lmi interface
configuration command
Cisco ME 3400 Ethernet Access Switch Command Reference
2-100
service instance
ethernet uni
ethernet lmi t392
Description
Enables Ethernet LMI for a user-network interface.
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
OL-9640-07