Cisco ME 3400 Command Reference Manual page 228

link state group
Examples This example shows how to configure the interfaces as upstream in group 2:
Switch# configure terminal
Switch(config)# interface range gigabitethernet0/11 - 14
Switch(config-if-range)# link state group 2 downstream
Switch(config-if-range)# end
Switch(config-if)# end
You can verify your settings by entering the show running-config privileged EXEC command.
Related Commands Command
link state track
show link state group
show running-config
Cisco ME 3400 Ethernet Access Switch Command Reference
2-202
Chapter 2
Description
Enables a link-state group.
Displays the link-state group information.
Displays the operating configuration. For syntax information, use this link to
the Cisco IOS Release 12.2 Command Reference listing page:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_command
_reference_list.html
Select the Cisco IOS Commands Master List, Release 12.2 to navigate to
the command.
Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
OL-9640-07