Ip Igmp Profile - Cisco ME 3400 Command Reference Manual

ip igmp profile

ip igmp profile
Use the ip igmp profile global configuration command to create an Internet Group Management
Protocol (IGMP) profile and enter IGMP profile configuration mode. From this mode, you can specify
the configuration of the IGMP profile to be used for filtering IGMP membership reports from a
switchport. Use the no form of this command to delete the IGMP profile.
Syntax Description profile number
Defaults
No IGMP profiles are defined. When configured, the default action for matching an IGMP profile is to
deny matching addresses.
Command Modes
Global configuration
Command History Release
12.2(25)EX
Usage Guidelines
When you are in IGMP profile configuration mode, you can create the profile by using these commands:
•
•
•
•
•
You can apply an IGMP profile to one or more Layer 2 interfaces, but each interface can have only one
profile applied to it.
Examples This example shows how to configure IGMP profile 40 that permits the specified range of IP multicast
addresses.
Switch(config)# ip igmp profile 40
Switch(config-igmp-profile)# permit
Switch(config-igmp-profile)# range 233.1.1.1 233.255.255.255
You can verify your settings by using the show ip igmp profile privileged EXEC command.
Cisco ME 3400 Ethernet Access Switch Command Reference
2-156
ip igmp profile profile number
no ip igmp profile profile number
The IGMP profile number being configured. The range is 1 to 4294967295.
Modification
This command was introduced.
deny: specifies that matching addresses are denied; this is the default condition.
exit: exits from igmp-profile configuration mode.
no: negates a command or resets to its defaults.
permit: specifies that matching addresses are permitted.
range: specifies a range of IP addresses for the profile. This can be a single IP address or a range
with a start and an end address.
When entering a range, enter the low IP multicast address, a space, and the high IP multicast address.
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
OL-9640-07