Interface Range - Cisco ME 3400 Command Reference Manual

interface range

interface range
Use the interface range global configuration command to enter interface range configuration mode and
to execute a command on multiple ports at the same time. Use the no form of this command to remove
an interface range.
Syntax Description
port-range
macro name
Defaults This command has no default setting.
Command Modes Global configuration
Command History Release
12.2(25)EX
Usage Guidelines When you enter interface range configuration mode, all interface parameters you enter are attributed to
all interfaces within the range.
For VLANs, you can use the interface range command only on existing VLAN switch virtual interfaces
(SVIs). To display VLAN SVIs, enter the show running-config privileged EXEC command. VLANs not
displayed cannot be used in the interface range command. The commands entered under interface
range command are applied to all existing VLAN SVIs in the range.
All configuration changes made to an interface range are saved to NVRAM, but the interface range itself
is not saved to NVRAM.
You can enter the interface range in two ways:
•
•
All interfaces in a range must be the same type; that is, all Fast Ethernet ports, all Gigabit Ethernet ports,
all EtherChannel ports, or all VLANs. However, you can define up to five interface ranges with a single
command, with each range separated by a comma.
Valid values for port-range type and interface:
•
•
Cisco ME 3400 Ethernet Access Switch Command Reference
2-114
interface range {port-range | macro name}
no interface range {port-range | macro name}
Port range. For a list of valid values for port-range, see the "Usage Guidelines"
section.
Specify the name of a macro.
Modification
This command was introduced.
Specifying up to five interface ranges
Specifying a previously defined interface-range macro
vlan vlan-ID - vlan-ID, where VLAN ID is from 1 to 4094
fastethernet module/{first port} - {last port}, where module is always 0
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
OL-9640-07