Cisco ME 3400 Command Reference Manual page 571

Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
Command History Release
12.2(25)EX
12.2(46)SE
12.2(50)SE
Usage Guidelines Specify the host (NMS) that receives the traps by using the snmp-server host global configuration
command. If no trap types are specified, all trap types are sent.
When supported, use the snmp-server enable traps command to enable sending of traps or informs.
Informs are not supported in SNMPv1.
Note
To enable more than one type of trap, you must enter a separate snmp-server enable traps command
for each trap type.
Examples This example shows how to send port security traps to the NMS:
Switch(config)# snmp-server enable traps port security
You can verify your setting by entering the show running-config privileged EXEC command.
Related Commands Command
show running-config
snmp-server host
OL-9640-07
Modification
This command was introduced.
The dot1x [auth-fail-vlan | guest-vlan | no-auth-fail-vlan | no-guest-vlan ] keywords
were added.
The cpu threshold keywords were added.
Description
Displays the operating configuration. For syntax information, use this link to
the Cisco IOS Release 12.2 Command Reference listing page:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_command
_reference_list.html
Select the Cisco IOS Commands Master List, Release 12.2 to navigate to
the command.
Specifies the host that receives SNMP traps.
Cisco ME 3400 Ethernet Access Switch Command Reference
snmp-server enable traps
2-545