Aiwa XR-H330MD Operating Instructions Manual page 19

DISC
DIRECT
PLAY
3,7
4
SHIFT
Programmed edit function enables CD recording
while checking
the remaining time on each side of the tape as the tracks are
prog ammed.
EExEl
The programmed edit recording will not start from a point
hallway in the tape, The tape must be recorded from the
beginning of either side.
. Set the blank skip play function to OFF ( page 12).
YOL can record up to 30 tracks by programmed edit function.
. You can set up to 30th track numbers by programmed edit
fun;tion,
1
2
3
4
5
Insert the tape for recording into deck 2.
Insert the tape with the side to be recorded on first facing out
from the unit.
Press CD and load the CD(s).
Press CD EDIT/CHECK twice
control while pressing SHIFT.
"PRGM" lights up,
on the remote
When "Al" is displayed, press
EDIT/CHECK
while pressing
SI+IFT again.
Press numbered buttons 0-9 on the remote
control to designate the tape length.
1() to 99 minutes can be specified.
44 and -, or
MULTI JOG
on the main unit are also
,Ivailable to designate the tape length.
Press DISC DIRECT PLAY 1-3 to select a CD.
Then,
press numbered buttons O-9 and +1 O to
program a track.
6
7
8
Repeat step 5 for the rest of the tracks for side A.
A track whose playing time is longer than the remaining time
cannot be programmed.
Selected track Program
number
number
Remaining time of side A
Selected disc number
Total number of
programmed tracks
Press CD EDIT/CHECK on the remote control
while pressing SHIFT to select side B anti
program the tracks for side B.
After confirming "B" on the display, repeat step 5.
Tape side B
Maximum recording time for side B
Press TAPE REC/REC MUTE to start recording.
The tape is rewound to the beginning of the front side, the
lead segment is played through for 10 seconds, and recording
starts. When recording on the front (side A) ends, recording
on the back (side B) starts.
To stop recording
Press . Recording and CD play stop simultaneously.
To check the order of the programmed track numbers
Before recording, press - repeatedly.
Tape side Program number
Track number
To change the program of each side
Press
EDIT/CHECK
on the remote control while pressing
SHIFT
to select side A or B, and press to clear the program of the
selected side. Then program the tracks again.
To clear the edit program
Press once in stop mode to return to the normal display.
ENGLISH
1$]