Connecting The Mk1200; Ac Power Supply; Wired Ethernet Connection - Motorola MK1250-0N0DAKBNTWR - Symbol Micro Kiosk MK 1250 Product Reference Manual

Connecting the MK1200

The MK1200 communication interfaces include both wired and wireless solutions:
•
Wired Ethernet (10 Base-T cable)
• Power via AC outlet (see below)
• Power via Symbol's BiasT Power-Over-Ethernet (see
•
Wireless Ethernet (11Mb RF)
•
Wired RS-232 (serial cable) (see
To configure the communications interfaces, see
CE Desktop, see Accessing the Windows® CE Desktop on page

AC Power Supply

The Symbol universal AC power supply has a positive center pin and the outer tab is ground. It is compatible with:
•
120V 60 Hz (North America)
•
230V 50 Hz (International excluding Japan)
•
100V 50/60 Hz (Japan).

Wired Ethernet Connection

With a wired Ethernet connection, Ethernet-enabled MK1200 models are powered either using the MK1200's
Symbol AC power supply, or by Power-Over-Ethernet through the Ethernet cable.
Wired Ethernet: Power via AC Outlet
The MK1200 communicates to the host via a 10 Base-T Ethernet cable and receives power via a Symbol AC
power supply.
Insert the power supply's barrel connector into the MK1200's power port. See
1.
Route the power cable.
2.
Plug the Symbol AC power supply into a wall outlet.
3.
Connect the Ethernet cable to the LAN port on the MK1200. See
4.
cable is terminated according to
Plug the other end of the Ethernet cable into the host system's LAN port.
5.
page
page 2-9).
Chapter 4, Remote Device
Table 2-2 on page 2-11.
2-8)
Manager. To access the Windows
7-7.
Figure 1-3 on page
Figure 1-3 on page 1-5. Ensure the Ethernet
Installation 2 - 7
®
1-5.