Aegis Client; Persisting Aegis Settings - Motorola MK1250-0N0DAKBNTWR - Symbol Micro Kiosk MK 1250 Product Reference Manual

B - 2 MK1200 MicroKiosk for CE .NET 4.2 Product Reference Guide

Aegis Client

Install the Aegis Client included in the platform partition 1150c42Plat32Mxxx.hex onto the MK1250 to
implement WPA enterprise wireless security. Wireless MK1250s ship from the factory with this client installed.
Use the Aegis Client to configure the MK1250's Spectrum24 wireless network settings. See Aegis Client
documentation for more information.

Persisting Aegis Settings

To permanently save the settings configured by the Aegis Client, run
. This creates the \Applications\Aegis.reg file containing the configured parameters.
Configuration
NOTE To deploy the same Aegis settings on multiple MK1250 devices, copy the Aegis.reg file to other MK1250
devices.
To save certificates installed on the MK1250 for use by Aegis Client, run
. This preserves the certificate across cold boot cycles.
Certificates
Using Certificates with Aegis Client
When the MK1250 is operating with the default system time after a cold boot (1st of June 1999 12:00:00 AM)
and cannot update its time over SNTP because it is not connected to the network, perform the following to use
certificates with Aegis:
Manually set the date and time.
1.
Install the certificate.
2.
Create a bat file, e.g.,
3.
date mm-dd-yyyy
time hh:mm:ss
Create a folder named
4.
Use Aegis to connect to the required network with the installed certificate.
5.
Select
6. Start > Programs > Tools > Save Certificates
to save them over power cycles.
IP Configuration of Aegis Client
The Aegis Client does not provide an interface to configure IP settings applicable for NETWLAN adapter. To
configure IP settings, on the MK1250, select
set the configurations. Then select
over cold boot cycles.
, as follows:
SetDate.bat
in the
StartUp Application
Start > Settings > Network & Dial-up Connections > NETWLAN
Start > Programs > Tools > Save Aegis Configuration
Start > Programs > Tools >Save Aegis
Start > Programs > Tools > Save
folder, and copy this bat file to it.
and
Start > Programs > Tools > Save Aegis Configuration
and
to preserve the settings