E - 8
MK1200 MicroKiosk for CE .NET 4.2 Product Reference Guide
Sending the Hex Image
After building the hex file, download it to the device using IPL. See
detailed procedures.
Saving the Script
Save the script if changes were made since last saving it.
TCM Error Messages
Select the Execute button to validate the cells in the partition table. Cells highlighted in red contain an error.
Partition loading is disabled until all errors are corrected. Following are errors that TCM can encounter and
possible solutions.
TCM Error Messages
Table E-2
Error
Failed to build images: flash file
system DLL not loaded!
Failure finding directory xxx
Failure creating volume
Failure adding system file to image
INVALID PATH
Nothing Selected To Build
Disk Full
Target Disk Full
Hex file is READ ONLY
Error opening the file xxx with write
access
Failure creating binary file
Hex File To load is missing or
invalid
Could not locate device name in
TCM.ini file
Description/Solution
TCM could not load the DLL required to build images for the target flash
file system. Reinstall TCM or recover the DLL.
Build process failed because directory xxx was not found.
Build process failed because a certain disk volume could not be
created.
Build process failed because TCM failed to add a certain system file to
the disk image.
The path for the image file to build is not valid.
In the
window, no item is selected to build.
Config Build
TCM failed to create Hex image file at the selected path. Check
available disk space.
Build process failed because TCM failed to add file to the image of a
disk volume. Remove some files or increase the disk size.
The Hex image file to be created exists and is read-only. Delete the
existing file or change its attribute.
TCM could not open file xxx with write access. Check if file is in use.
TCM failed to open/create an intermediate binary file.
In
window, the file selected to load has invalid status.
Load Terminal
While loading the
Script Properties
TCM.ini section corresponding to the device type specified by the
current opening script. Either TCM.ini or the script file is invalid.
IPL Menu Navigation on page F-3
window, TCM could not find the
for