Connecting Power (If Required); Synapse Interface - Motorola Symbol LS9208 Product Reference Manual

Connecting Power (if required)

If the host does not provide power to the scanner, connect external power to the scanner:
Connect the interface cable to the back of the scanner, as described in
1.
1-2.
Connect the other end of the interface cable to the host (refer to the host manual to locate the correct port).
2.
Plug the power supply into the power jack on the interface cable.
3.
Plug the other end of the power supply into an AC outlet.
4.

Synapse Interface

Auto-detection of a Synapse cable varies in duration depending on the type of Synapse connection. If a scanner is
connected to a host using a Synapse cable, use the Auxiliary Synapse Port connection. In all other cases when
using a Synapse cable, use the default setting.
To disconnect and reconnect the scanner from a Synapse cable that is connected to a live host, use the Plug and
Play setting. Do not change this setting from the default if an on-board wedge host is enabled.
*Standard Synapse Connection
Getting Started
Installing the Interface Cable on page
1 - 3