System Keys; System Bits - SMC Networks aPNEUALPHA2 Series Programming Manual

α
PneuAlpha2 Simple Application
8.2

System Keys

Key Name
OK
ESC
"+"
"-"
( )
( )
( )
( )
8.3

System Bits

System Bit
M01
M02
M03
M04
M05
M06
M07
M08
M09
M10
M11
M12
M13
M14
Key number
Used to enter menu options, confirm data entry, and manually force
K01
inputs ON/OFF in the monitor function.
Used to cancel an operation, move to a higher level screen, or to
K02
move to a new menu.
Used to connect (or "add") function blocks, increase Direct Set input
K03
values or times, or move through programs or menus.
Used to disconnect function blocks, decrease Direct Set values or
K04
times, or move through programs or menus.
Scroll up through menu options (menus, keys, FB, Inputs, Outputs,
K05
etc.)
Scroll down through menu options (menus, keys, FB, Inputs, Outputs,
K06
etc.)
K07 Move to the right on the LCD display, FB program, or Jump command
K08 Move to the left on the LCD display, FB program, or Jump command
Always "ON".
Always "OFF".
Alternate - 0.5 seconds "ON", 0.5 seconds "OFF".
"ON" when Real Time Clock data error occurs.
"ON" when Summer time schedule is activated.
"ON" when AS-interface communication Error occurs.
"ON" when communication Error caused by AS-interface power failure occurs.
"ON" when Stop mode turns to Run mode in the
signal acts as a pulse output and then turns "OFF".
"OFF" when Stop mode turns to Run mode in the
signal acts as a pulse output and then turns "ON".
Reserved
Reserved
"ON" when CD (DCD) signal is turned ON (receiving CD signal from the modem.)
"ON" when it is possible to access the GSD network.
α
"ON" when the PneuAlpha2 series controller is accessed via ECC-PNAL2-GSM-
CAB.
Key Function
Description
α
PneuAlpha2 Series. The "ON"
α
PneuAlpha2 Series. The "OFF"
Appendix 8
8 - 2