Creating Numeral Setting Input Fields - Omron NT - SUPPORT TOOL 07-1995 Operation Manual

Creating Input Settings
4-9-1

Creating Numeral Setting Input Fields

Procedure 1. Select "IN SET" from the initial editing screen.
Reference: When using direct connection, to "increment copy" an existing entry into the next
This is the procedure for creating input fields for numeral settings. For details on
the display of numeric values, setting display colors (NT30C and NT610C), setting
numeral tables, and setting words and bits, see 4-2 "Common Setting Operations"
(p.61).
The input setting menu will be displayed.
2. Select "DATA IN" from the input setting menu.
3. Select the field in which the numeral setting input field is to be registered and
press the key.
To delete an existing numeral setting from the field in which it is registered, lo-
"
cate the cursor at that field and press the [F1] (Delete) key.
input field (incrementing the memory table number), press the [F2] (iCopy) key
with the cursor located on that entry. Note that there must also be an entry in the
next input field. (See p.77).
4. If the input type can be specified, specify either "Number Input" or "Thumb-
wheel", specify "Mv Crsr Sw" if necessary, then press the
If the thumbwheel type cannot be used, the input type selection window will not
"
be displayed.
If "Mv Crsr Sw" is set for "Yes", touch switches for which the "cursor motion"
"
function has been set will be automatically created and displayed overlying the
input field (this function is not available when using the thumbwheel input type).
Section 4-9
key.
131