Table of Contents
Advertisement
"Tool Settings" Screen
3-3
"Tool Settings" Screen
Settings
22
This screen is used to set the environmental settings required to use the support
tool, such as the PT model, capacity of the screen data memory board, and the
directory in which data is saved.
When using the support tool for the first time, this screen is displayed first. Be sure
to set the tool settings in accordance with the model you are using. After this first
setting, it will not be necessary to set the tool settings again unless there is some
change.
When "Tool Settings" is selected from the main menu, the "Tool Settings" screen is
displayed. For details on the permissible combinations of settings, see "PT Model
and Tool Settings" (p.xiv) at the beginning of this section.
<"Tool Settings" screen>
S PT Type:
Note
The specified PT Type setting is different from the actual PT model in the following
cases:
NT20S-ST121 (without [-V1]):
NT612G:
NT620S:
NT620C:
S Memory Size:
S Direct Access:
S Direct Macn Type:
\
\
Specify the model of PT being used.
[NT20M]
[NT610G]
[NT610G]
[NT610C]
Specify the capacity of the screen data memory
board installed in the PT.
Specify the direct connection version. If not using
the direct connection function, set "Ver.4" for the
NT20S, NT20M, NT600S, and NT600M. "NONE"
cannot be set for NT612G/610C or NT620C/S.
Set "NONE" if direct connection is not used. Set
"OMRON" if direct connection is used.
Section 3-3
Advertisement
Table of Contents
