Table of Contents
Advertisement
Creating Fixed Displays
4-3-3
Creating Polylines
Procedure 1. Select "FIX DSP" from the initial editing menu.
Deleting Polylines
Procedure 1. Select "POLYLINE" from the fixed display menu and then press the [F1] (De-
84
This is the procedure for drawing continuous lines (polygonal lines). It is possible
to connect a maximum of 255 individual line segments.
The fixed display menu will be displayed.
2. Select "POLYLINE" from the fixed display menu.
3. Select the type of line.
The selectable options are solid line, broken line, 1-dot chain and 2-dot chain.
It is not possible to use more than one line type in the same continuous line.
"
4. If using an NT30C or NT610C, specify the line color.
5. Press the
key with the cursor on "Exec"
6. Draw the continuous line.
1) Press the
key at the start point.
2) Locate the cursor at an intermediate point and press the
Set as many intermediate points as required.
3) At the end point, press the
double click if using the mouse).
(
)
Start point
Pressing the [Esc] key before the end point has been set deletes the last drawn
"
line segment.
Pressing the [Esc] key while holding down the [Shift] key aborts the drawing.
"
7. Press the [Esc] key to quit continuous line drawing.
lete) key.
A j mark will be displayed at the start point of the continuous line.
2. Locate the cursor at the j mark of the continuous line to be deleted and press
the
key.
3. Check the message and then press the
leted.
To abort deletion, press the [Esc] key.
key while holding down the [Shift] key (or
End point
Intermediate
(Shift+
points
(
)
key; the continuous line will be de-
Section 4-3
key.
)
Advertisement
Table of Contents
