Table of Contents
Advertisement
Common Setting Operations
Reference: If the host interface unit's DIP switch is set for initialization of the data contents of
Procedure 1. Locate the bar cursor at the number of the numeral table to be set.
Reference: S Data can be copied into the next numeral memory table by pressing [F2] (iCopy).
S In:
Execution/non-execution of numeral table initialization in
accordance with initial values set using the support tool
when the PT is started up.
S #:
Number of words used at the PC for reference by the
numeral table.
S Word:
First word (lower word) in the data area at the PC
referenced by the numeral table.
The entry in the parentheses to the right is a comment input
when word setting was performed. It gives information such
as the contents of the word.
When direct connection is not used, only "Init Val" can be set.
the allocated words in the PC, the "Initial Value" setting will be invalidated.
<Setting method>
[Shift] + [ ] or [Shift] + [ ] can be used to move the bar cursor to the previous or
"
next numeral table for which the "Init Val" setting is not "0".
Press the [Tab] key to display the memory table number input field.
"
Press the [F1] (Ref) key to display the screen number that references a particu-
"
lar numeral table.
Press [F5] (Srch) to search for initial values or allocated words. See "Search-
"
ing within a Memory Table" (p.78).
Incrementing processing is performed in accordance with the setting made with
[F3] (iCopySet). See "Copying to the Next Input Field (Increment Copy)" (p.77).
S Allocated bits of a numeral memory table can be changed in a batch with a desig-
nated range by pressing [F4] (Btch Chng). See "Batch Changing Bits and
Words" (p.79).
2. Press the
key in the "Init Val" input field, input the initial value of the numeral
memory table, then press the
Input numerical values can be deleted by pressing the [Home] key.
3. If using direct connection, to initialize the numeral memory table when it is
started, move the bar cursor to the "In" input field and press the [SPACE] (Init)
key.
4. If using direct connection, press the
ber of words (1 or 2), then press the
5. Carry out word setting.
For details of the setting procedure, see "Setting Words and Bits" (p.75).
key again.
key in the "#" input field, input the num-
key again.
Section 4-2
69
Advertisement
Table of Contents
