Table of Contents
Advertisement
Transmitting Data
7-2
Transmitting Data
Transmitting Data in File Units
Procedure 1. Set the PT to the "Transmit Mode".
Reference: When data transmission has been aborted part way through, initialize the image
188
This is the procedure for transmitting data such as image data or memory table
data to the PT, and writing it into the flash memory type data memory of the PT.
There are two methods for transmitting data, as follows:
S Selecting a file from the "File Selection" screen and transmitting it to the PT.
S Selecting a screen from the "Screen Selection" screen and transmitting it to the
PT.
Select a file from the "File Selection" screen and transmit it to the PT.
Check that the write switch of the screen data memory board is released.
"
2. Locate the bar cursor on the file to be sent on the "File Selection" screen.
3. Press the [F6] (Tmx.) key.
4. A message will be displayed for the purpose of confirmation.
Check the message and press the
Press the [Esc] key to abort data transmission.
"
5. Data transmission will start.
On completion of the transmission, the message "Data successfully trans-
mitted." will be displayed.
Press the [Esc] key to stop transmission part way through.
"
data memory: do this by using the DIP switch on the PT.
For details, refer to the operation manual for the PT.
Also initialize the image data memory by this means if data transmission is
stopped due to trouble.
Section 7-2
key.
Advertisement
Table of Contents
