Table of Contents
Advertisement
Error Messages
Error Message
3,000 I/O comments registered.
No more can be registered.
One screen exceeds 16 Kbytes.
Image/Library area exceeds 64 KBytes.
The number of bits for cross-referencing
has exceeded 3000.
Not usable with this version.
Check usable functions and adjust the tool settings.
This file can't be sent.
Check the tool settings and file (detailed info).
Work directory disk capacity insufficient.
Data directory disk capacity insufficient.
Seek error detected.
Disk is faulty.
Sector not found.
Check the direct access version.
Error detected in the data
Disk may be broken.
Disk is protected.
[ G G : Retry
G G : Abort ]
Disk not ready.
[ G G : Retry
G G : Abort ]
Too many registered channels: correct to MAX value?
( G G Yes/ G G Abort)
APPENDIX B
Error Messages
The error messages that may be displayed while using the support tool, and the
action to take in response to them, are shown below.
(Confirm)
If there unnecessary comments, delete them.
(Confirm)
The maximum data size for one screen is 16 Kbytes. If there is
unnecessary data, delete it (see 3-5 "Screen Selection Screen"
on p.31).
(Confirm)
Delete unnecessary data.
If there is unnecessary screen data, delete it.
(Confirm)
(Confirm)
The current tool settings ("PT Model", "Direct Access") do not
correspond with the specified function.
(Confirm)
Files displayed in red cannot be transmitted. Match the tool
settings with the file to be transmitted.
(Confirm)
Set the data in a directory with sufficient free area (1 MB or
greater).
greater)
(Confirm)
(Confirm)
The disk is damaged, or the drive may be faulty. Either replace
the disk or inspect the disk drive.
the disk or inspect the disk drive
(Confirm)
(Confirm)
Initialize (format) the disk in DOS format before using it.
(Confirm)
Adjust the tool settings to match the direct connection version of
the selected file.
(Confirm)
Part of the data has been destroyed and it cannot be used as it
is. Delete the data and create it again. Or, if there is backup
data, use that.
(Confirm)
Replace the disk. If there is a backup disk, use that.
(Confirm)
Try again after releasing the disk's write protection.
(Confirm)
Set the floppy disk correctly in the designated drive and try
again.
The number of registered counter words has been set to two or
more by a batch change operation: this is automatically cor-
rected to one word (see "Batch Changing Bits and Words",
p.79).
Appendix B
Corrective Action
195
Advertisement
Table of Contents
