Table of Contents
Advertisement
Preparation and Procedure for Data Communication with the PT
Types of Data Communication with Each PT Model
Procedure for Data Communication
Reference: For details on the operations at the PT side, refer to the operation manual for the
There are two methods for data communication, as follows:
S Data communication in file units executed using the "File Selection" screen
S Data communication in screen units executed using the "Screen Selection"
screen.
Whether or not data communication in file units or screen units can be used is
shown in the table below for each PT model.
PT Model
NT20S
NT20M/NT2000M
NT600S
NT600M
NT30
NT30C
NT612G
NT610C
NT620S
NT620C
*: In the NT20S/NT600M compatible mode, simultaneous transmission of multi-
ple screens and verification are not possible.
Use the following procedure to make preparations at the PT and support tool sides
and execute data communication.
<Procedure at PT side>
Connect to the support tool
Display the system menu
Select "Transmit Mode"
Return to "Run Mode"
PT.
File Units
f
f
f
f
f
f
f
f
f
f
f: possible n: partly possible x: not possible
<Procedure at the support tool side>
Execute the transmit or receive function
Transmission or reception
Section 7-1
Screen Units
ST121:
x
ST121-V1: n*
ST122-V1: n*
ST128:
f
f
n*
f
x
x
x
x
x
x
Connect to the PT
187
Advertisement
Table of Contents
