Table of Contents
Advertisement
Receiving Data
7-3
Receiving Data
7-3-1
Data Reception
Receiving Data in File Units
Procedure 1. Set the PT to the "Transmit Mode".
190
This is the procedure for receiving screen data, memory table data, display histo-
ries, etc., from the PT and storing this data as support tool files, and for receiving
data in screen units, and writing it to the screen data of the support tool.
Use the following procedure to receive all the data in the data memory and write it
to a file.
There are two methods for receiving data, as follows:
S Receiving all the data in the PT's data memory and writing it to a file.
S Receiving data in screen units and writing it to the support tool.
2. Display the "File Selection" screen.
It does not matter where the bar cursor is.
3. Press the [F7] (Rcv.) key.
4. Input the file name of the file to which the received data is to be written.
5. Press the
key.
File reception will start.
If a file that already exists is specified, a message asking whether or not the file
"
is to be overwritten will be displayed. If you do not want to overwrite it, press the
[Esc] key.
Press the [Esc] key to stop reception part way through.
"
On completion of reception, the message "Data successfully transmitted" will
be displayed.
Section 7-3
Advertisement
Table of Contents
