Table of Contents
Advertisement
"File List" Screen
Functions of the Function Keys
[Copy]
[Delete]
(g) File information:
The support tool allows the creation of up to 200 "files" (the number may be smaller
than this due to restrictions on the number of files per DOS directory). If the re-
quired file is not displayed on the screen, screens earlier and later in the sequence
can be displayed by using the [Page Down] and [Page Up] keys, or icons.
Depending on the direct connection version of the model used, it may or may not
be possible to use certain files.
Files that cannot be used are displayed in red.
To use more than 200 files, create another directory. The data directory can be
changed by using the "Tool Settings" option.
All the files in the specified data directory are displayed.
The files that correspond to the "PT Type" and "Direct Access" set in the "Tool
Settings" are first in the order of display. The other files are displayed in the fol-
lowing order: 20M, 20S, 600M, 600S, 612G, 610C, 30, 30C; files corresponding
to the same model are displayed in order of direct connection version.
It is possible to read files set using other models but you are advised to check the
details of the file information displayed when the file is specified before reading it.
It is also possible to read files created using previous support tool versions.
Returning to the main menu
To return to the main menu, press the [Esc] key.
[F1]
. . .
Copy file
Used to copy the contents of a file to another file (copying in support tool "file"
units).
(1) Press the [F1] (copy) key.
(2) Select the file to be copied.
(3) Input the file name and title of the copy destination and press the
If [F1] (drive) is now selected, the file can be copied to the directory of another
"
drive.
[F2]
. . .
Delete file
Used to delete unnecessary files (deletion in support tool "file" units).
(1) Locate the bar cursor at the file to be deleted and press the [F2] key.
(2) Check the file name and then press the
The NT model, direct connection version, direct
connection indication, and file size for the file at
which the bar cursor is located are displayed here.
Even if direct connection is not used, the version
is displayed as "V4" when using an NT20M,
NT20S, NT600M, or NT600S.
key: the file will be deleted.
Section 3-4
key.
27
Advertisement
Table of Contents
