Table of Contents
Advertisement
Setting Lamps
4-6-2
Modifying Lamps
Procedure 1. Select "LAMP" on the initial editing screen.
104
It is possible to modify the contents, shape, and position of created lamps.
It is also possible to proceed straight to step 3. by left clicking on the lamp to be
"
modified (see p.57).
2. Select the type of modification from the options in the window ("Lamp Type
Set" column) and press the
It is also possible to select the lamp to be modified by left clicking on it (this ap-
"
plies to displayed lamps only: depending on the setting for "Lamp/Touch Sw
Disp Mode" in the environmental settings, image/library lamps may not be vis-
ible).
For "Bit" (lamp bit) and "Label", direct modification is possible by locating the
"
cursor where the modification is to be made and pressing the
3. Select the type of modification from the options in the window and execute the
modification.
For a "Normal lamp"
S Set Display:
S Area Position:
S Attrib Posiiton:
S Label Posiion:
S Ptot Position:
S Light Positioin:
4. Press the [Esc] key to quit modification.
key.
For an "Image & library lamp"
Select to modify the item specified in the window
during setting.
Select to modify the shape of the lamp graphic.
Select to change the starting position for tiling when
the lamp is on or flashing. This item can only be
used when a polygonal lamp is selected.
Select to modify the position at which the label is
displayed.
Select to modify the position at which image/library
data is displayed when the lamp is off.
Select to modify the position at which image/library
data is displayed when the lamp is on.
Section 4-6
key.
Advertisement
Table of Contents
