Table of Contents
Advertisement
Creating Fixed Displays
Modifying Fans
Procedure 1. Select "FAN" from the fixed display menu, then press the [F2] (Modify) key.
4-3-8
Tiling
Procedure 1. Select "FIX DSP" from the initial editing menu.
A j mark will be displayed at the center of the fan.
It is also possible to proceed straight to step 3. by left clicking on the fan to be
"
modified (see p.57).
2. Locate the cursor at the j mark of the fan to be modified and press the
3. Select the required item and execute the modification.
S Attribute:
Select to change the display attribute.
S Color:
If using an NT30C or NT610C, select to change the line
color.
S Display position:
Select to move the end point of the fan.
Pressing the [Esc] key makes it possible to change the start
point and center point also.
After changing the shape, press the
4. Press the [Esc] key to quit modification.
This is the procedure for filling an area enclosed by lines, such as a square or
circle, with a specified tiling pattern.
It cannot be used if using an NT20S, NT20M, NT600S, or NT600M.
The fixed display menu will be displayed.
2. Select "TILING" from the fixed display menu.
3. Select the tiling pattern with "Detail".
4. If using an NT30C or NT610C, specify the base color, background color, and
boundary color.
5. Press the
key with the cursor on "Exec"
6. Locate the cursor inside the area to be tiled and press the
Any point inside an area that is enclosed by solid lines can be specified.
If using an NT30C or NT610C, make the specification inside the boundary col-
or area.
7. A message asking for confirmation that the area is to be tiled will be displayed.
Section 4-3
key.
key.
key.
93
Advertisement
Table of Contents
