Omron NE1A-SCPU01 - 2006 Operation Manual page 48

System Configuration
NE1A Standalone System
IMPORTANT Use a USB port connection to set Standalone Mode. DeviceNet communica-
If there are only a few I/O points, the NE1A-series Controller can be used as
Standalone Controller.
The Controller's DeviceNet communications can be disabled through settings
made from the Network Configurator to enable the NE1A-series Controller to
operate as Standalone Controller.
Emergency stop
buttons
USB communications
Network Configurator
tions are stopped when Standalone Mode is set, and so setting is not possible
from the DeviceNet port.
Door switches Two-hand switches
NE1A
(Standalone)
Contactors
Section 1-2
13