Command Reference: Function Blocks
Optional Output Settings
Reset Signal
130
The outputs shown below can be used in the program. To enable either of
these outputs, select the checkbox on the Out Point Tab Page of the function
block properties dialog box.
• Static Release
• Reset Required Indication
Maximum Number of Inputs and Outputs for a Reset Logic Function
The Reset signal must meet the following conditions.
350 ms min.
In NE1A-series Controllers with unit version 1.0 or later, the Low-to-High ris-
ing edge can be selected. To enable this signal, set the Reset Signal to Rising
Edge on the Parameter Tab Page of the function block properties dialog box.
Section 6-5