Omron CX-INTEGRATOR - V1.1 Operation Manual page 60

1-6 Menus
1-6-2 Pop-up Menus
Pop-up Menu for Communications Units/Ports under TargetPLC Online
Pop-up menu
Transfer [Network to PC]
Connect
Start Data Link
Start Routing Table
NT Link Tool - NT Link
Auto Online Setting
Controller Link Tool –
Network diagnosis
Ethernet tool – Ping test
Echoback test between
PLC nodes
1-40
Description
Uploads the communications configuration
of the selected Communications Unit/port.
Enables accessing the selected
Communications Unit/port.
Starts the Data Link Component. (Controller
Link or SYSMAC Link only)
Starts the Routing Table Component.
Automatically detects the communications
settings of an NS-series PT that is
connected serially to the selected
Communications Unit/port, overwrites the
PLC serial port's communications settings
to match them, and connects automatically.
Starts the Controller Link Network
Diagnostic Tool.
Starts the Ethernet ping test tool.
Starts the echoback test for checking the
communications status of the network.
Online
Offline
Not
connected
No No OK
No OK OK
No OK OK
No OK ---
No OK OK
No OK OK
No OK OK
No OK OK
Connected