Omron CX-INTEGRATOR - V1.1 Operation Manual page 170

4-3-5 Procedure Using Setup Example
Set Area 1 for each node, based on the data link setup example in the example
system configuration.
Note: The receive size and reception offset can only be set for Controller Link, and not for
Setting Node Address 01
1 Select node address 01 from the node address list on the left. Node 01 will be
highlighted.
The data link table for node address 01, the node to be edited, is displayed as a list
in the Node Editing Window on the right.
Local node send area
Receive area from remote
nodes
With node address 01, the node refresh sequence matches the default (order of
Note
addresses), so no change is required.
With node address 01, the size and offset are both automatically displayed as the
defaults, so no changes are required.
2 With node address 01, the node refresh sequence matches the default (order of
addresses), so no change is required.
With node address 01, the size and offset are both automatically displayed as the
defaults, so no changes are required.
Settings for area 2 are made using the same method.
SYSMAC LINK.
Select node address 01 as the object to be edited.
Indicates the node refresh
sequence. (In this example,
for node address
change is required.)
The size and offset can be set.
Automatically displayed.
4-3 Manually Setting Data Links
4-3-5 Procedure Using Setup Example
The data link data for the selected node
address is displayed here.
Sends 30 words from the local node (node
address 01), starting with CIO 01000 (i.e., CIO
01000 to CIO 01029).
Receives 30 words from node 02, starting with
CIO 01230 (i.e., CIO 01230 to CIO 01259) into
the local node area starting with CIO 01030 (i.e.,
CIO 01030 to CIO 01059).
Receives 40 words from node 03, starting with
CIO 00350 (i.e., CIO 00350 to CIO 00389) into
01, no the local node area starting with CIO 01060 (i.e.,
CIO 01060 to CIO 01099).
4-23