Omron CX-INTEGRATOR - V1.1 Operation Manual page 157

4-3 Manually Setting Data Links
4-3-2 Creating Data Link Tables
2. Node Editing Window Settings
Note 1. It is possible to add or delete nodes from the participating data link nodes (1) using the
Add
Delete
Note 2. It is possible to change the following items set by the Datalink Wizard for each node: (2)
Note 3. The node refresh sequence is set using F4: Move Up Area and F5: Move Down Area.
The operations differ for Controller Link and SYSMAC LINK when creating data
Note
links.
The following table shows the points on which the manually set data link functions
are different.
These four differences apply even to data link setup operations using the
CX-Integrator. Aside from these points, other operations are basically the same.
4-10
(7) Set receive sizes from remote nodes.
(8) Set offsets.
Datalink Wizard.
Adding nodes
Adding link words
Deleting specified nodes or link areas
Deleting link areas from specified nodes
PLC type, (3) Area (memory area and start address), (4) Send size, (5) Node refresh
sequence (see note 3), and (6) Status area.
Function
(1) Offset setting
(2) Receive size setting
(3) Memory area
(4) Communications cycle time
setting
Select Table - Add Source Link.
Select Table - Add Destination.
Select the node from the node list, and
then click F8: Delete Node.
Select the node from the table, and
then click F8: Delete Node.
Controller Link
Supported
Supported
Area 1: Can be selected.
Area 2: Can be selected.
(CIO, LR, DM, EM, etc.,
according to PLC type)
Not supported
SYSMAC LINK
Not supported
Not supported. (It is only possible
to specify whether all of none of
the data sent is to be received.)
Area 1: CIO
Area 2: DM
(Fixed.)
Supported