Omron CX-INTEGRATOR - V1.1 Operation Manual page 168

Changing Node Refresh Sequences
The node refresh sequence set for each node by the Datalink Wizard can be changed
in the Node Editing Window.
In the Node Editing Window, select the node for which the refresh sequence is to be
changed.
Change the node refresh sequence by either clicking F4:
Move Up Area or F5: Move Down Area in the Function Bar,
or pressing the F4 or F5 function keys.
The node refresh sequence for individual nodes cannot be checked in the Data Link
Note
Configuration Window. Node refresh sequence checking and changes must be
performed in the Node Editing Window.
Adding Participating Nodes to Data Links
In the Node Editing Window, it is possible to add nodes aside from the participating
nodes set by the Datalink Wizard's Network Nodes setting.
The following window is displayed by selecting Table - Add Source Node from the
Datalink Component Menu or by clicking the
Specify the node address, PLC type, and the Area 1 and Area 2 memory areas, and
then click the OK Button.
4-3 Manually Setting Data Links
4-3-4 Creating Data Link Tables Offline
Button in the Toolbar.
4-21