Autel MSOBD2KIT User Manual page 57

A confirmation screen displays when the clear codes option is selected to prevent
accidental loss of data. Select Yes on the confirmation screen to continue, or No to exit.
4.11.2.2 I/M Readiness
This function is used to check the readiness of the monitoring system. It is an excellent
function to use prior to having a vehicle inspected for state emissions compliance.
Selecting I/M Readiness opens a submenu with two choices:
Since DTCs Cleared — displays the status of monitors since the last time the DTCs

were erased.
This Driving Cycle — displays the status of monitors since the beginning of the

current drive cycle.
4.11.2.3 Live Data
This function enables the display of real-time PID data from the ECU. Displayed data
includes analog and digital input and output, and system status information broadcast in
the vehicle data stream.
Live data can be displayed in various modes. See
4.11.2.4 Oxygen Sensor Monitor
This function allows retrieval and review of recent Oxygen sensor monitor test results
stored on the vehicle on-board computer.
The Oxygen Sensor Monitor test function is not supported by vehicles that communicate
using a controller area network (CAN). For Oxygen Sensor Monitor tests results of CAN-
equipped vehicles, refer to
4.11.2.5 On-Board Monitor
This function allows you to view the results of On-Board Monitor tests. The tests are
useful after the service when a vehicle control module memory is already erased.
4.11.2.6 Component Test
This function enables dual-directional control of the ECU so that the diagnostics tool can
transmit control commands to operate the vehicle systems. This function is useful in
determining how well the ECU responds to a command.
4.11.2.7 Vehicle Information
This function enables the display of the vehicle identification number (VIN), calibration
identification number, calibration verification number (CVN), and other test vehicle
information.
On-Board Monitor.
49
Live Data for detailed information.