A-Arm Replacement - Polaris RANGER 2x4 Manual

BODY/STEERING/SUSPENSION
A-ARM REPLACEMENT (ALL MODELS)
1. Elevate and safely support vehicle with weight removed from front wheel(s).
2. Remove cotter pin from ball joint stud at wheel end of A-arm and loosen nut until it is flush with end of stud.
3. Using a soft face hammer, tap nut to loosen A-arm from bolt. Remove nut and A-arm from hub strut assembly.
4. Loosen two bolts on A-arm bushing by alternating each about 1/3 of the way until A-arm can be removed.
5. Examine A-arm bushing and A--arm shaft. Replace if worn. Discard hardware.
6. Insert A arm bushings and A-arm shaft into new A-arm.
NOTE: On AWD models, install CV joint shields. See Illustration
Washer
Bolt 30 ft. lbs.
(41 Nm)
A--Arm Bushing
7. Install new A-arm assembly onto vehicle frame. Torque new bolts to 30 ft. lbs. (41.4 Nm).
WARNING
The locking features on the existing bolts were destroyed
during removal. DO NOT reuse old bolts. Serious injury
or death could result if fasteners come loose during
operation.
8. Attach A-arm to hub strut assembly. Tighten ball joint
nut to 25 ft. lbs. (35 Nm). If cotter pin holes are not
aligned, tighten nut slightly to align. Install a new cotter
pin with open ends toward rear of machine. Bend both
ends in opposite directions around nut.
WARNING
Upon A-arm installation completion, test vehicle at low speeds before putting into regular service.
5.12
Vehicle Frame
A-Arm Shaft
CV Joint Shield
(4x4 Models)
Bolt 30 ft. lbs.
Washer
(41 Nm)
25 ft. lbs
(35 Nm).
Cotter Pin
A-arm Attaching Bolt Torque:
30 ft. lbs. (41 Nm)
Ball Joint Stud Nut Torque:
25 ft. lbs. (35 Nm)
Apply Loctitet 242
Ball Joint
Stud
8 ft. lbs.
(11 Nm)