FX
Series Programmable Controllers
3G
User's Manual - Hardware Edition
9.2.3
Terminal block (for europe) [expansion board and special adapters]
The expansion board and special adapters of a terminal block type have terminal blocks for Europe.
1. Applicable products
Classification
Expansion Board
Special Adapters
2. Electric wires
Compliant electric wires and tightening torque
0.3mm
One electric wire
(AWG22 to 20)
Two electric wires 0.3mm
0.3 mm
Bar terminal with
(AWG22 to 20)
insulating sleeve
(Refer to the following outline
drawing of bar terminal.)
3. Treatment of electric wire ends
Treat the ends of stranded wires and solid wires without coating or using bar terminals with insulating sleeve.
• Treatment of stranded wires and solid wires without coating
- Twist the ends of stranded wires tightly so that loose wires will not
stick out.
- Do not solder-plate the electric wire ends.
• Treatment using bar terminal with insulating sleeve
It may be difficult to insert the electric wire into the insulating sleeve
depending on the thickness of the electric wire sheath. Select the
electric wire referring to the outline drawing.
Manufacturer
Phoenix Contact
4. Tool
• For tightening the terminal, use a commercially available small
screwdriver having a straight form that is not widened toward the end as
shown right.
Caution :
If the diameter of screwdriver grip is too small, tightening torque will not be
able to be achieved. Use the following recommended screwdriver or an
appropriate replacement (grip diameter: approximately 25mm (0.98") ).
Manufacturer
Phoenix Contact
FX
-485-BD, FX
-2AD-BD, FX
3G
3G
FX
-485ADP(-MB), FX
-4AD-ADP, FX
3U
3U
FX
3U
-4AD-PNK-ADP, FX
3U
-4AD-TC-ADP
Electric wire size
Tightening
(stranded wire/solid wire)
2
2
to 0.5mm
2
(AWG22)
0.22 to 0.25N•m
2
2
to 0.5 mm
Model names
AI 0.5-8WH
9 Preparation for Wiring and Power Supply Wiring
Model names
-1DA-BD
3G
-4DA-ADP, FX
-4AD-PT-ADP, FX
3U
3U
torque
•
Remove the coating of the stranded wire, twist the core wires,
and connect the wires directly.
•
Remove the coating from the solid wire, and connect the wire
directly.
•
Bar terminal with insulating sleeve
(recommended product)
AI 0.5-8WH : Phoenix Contact
•
Caulking tool
CRIMPFOX ZA 3 : Phoenix Contact
(CRIMPFOX UD 6 : Phoenix Contact)
Caulking tool
CRIMPFOX ZA 3
(CRIMPFOX UD 6)
Model names
SZS 0.4 x 2.5
9.2 Cable Connecting Procedures
-4AD-PTW-ADP,
3U
End treatment
Stranded wire/solid wire
9mm
(0.36")
Bar terminal with insulating sleeve
Insulating sleeve
Contact area
(Crimp area)
8mm
(0.32")
2.6mm
(0.11")
14mm(0.56")
With
straight tip
0.4mm
2.5mm
(0.02")
(0.1")
109
1
2
3
4
5
6
7
8
9
10