Table of Contents
Advertisement
CUTMASTER 50+, CUTMASTER 70+
3T.04
Setting Up Automation or Machine Torch
NOTE!
An adapter is required to be installed in the power supply if converting a hand torch system to operate a machine
or automation torch.
WARNING
Disconnect primary power at the source before disassembling the torch or torch leads.
The Automation and Machine torch include a positioning tube with rack and pinch block assembly.
1.
Mount the torch assembly on the cutting table.
2.
To obtain a clean vertical cut, use a square to align the torch perpendicular to the surface of
the workpiece.
Workpiece
3.
The proper torch parts (shield cup, tip, start cartridge, and electrode) must be installed for
the type of operation. Refer to Section 4T.08, Torch Parts Selection for details.
36
Automated and Machine Torch Set - Up
INSTALLATION
Pinch Block
Assembly
Square
A-02585
0700 402 229
Advertisement
Table of Contents
