Table of Contents
Advertisement
CUTMASTER 50+, CUTMASTER 70+
2.
Work lead Dinse type receptacle
Align Dinse type connector on work lead with receptacle, press in and turn clockwise to the right
until tight.
3.
Torch Quick Disconnect Receptacle
Torch Leads are connected here by aligning the connectors, pressing in and turning locking ring clock-
wise-to-the-right to secure. Connection should only be snug with no tools used.
8 - Open
7 - Open
6 - Open
5 - Open
Pilot
4.
Automation Interface Cable Port
Refer to sections 3T.02 and 3T.03.
5.
LCD screen (Cutmaster 70+ shown as example)
The front panel has an LCD screen to display the cutting mode, cutting current, cutting voltage, air
pressure, and error information.
WELCOME SCREEN
The welcome screen is displayed for 3 seconds while the equipment turns ON.
After the welcome screen, the model name is displayed for 3 seconds.
38
Negative /
Plasma
8
4
7
3
6
2
5
1
1 - PIP
OPERATION
4 - Switch
3 - Switch
2 - PIP
Trigger Switch
0700 402 229
Advertisement
Table of Contents
