03 Machine And Hand Torch Parts Selection - ESAB CUTMASTER 50+ Operating Manual

CUTMASTER 50+, CUTMASTER 70+
Torch parts:
Shield Cup, Cutting Tip, Electrode and Start
Cartridge
NOTE!
Refer to Sections "4T.02 Automation Torch Parts
Selection" and following for additional informa-
tion on torch parts.
Change the torch parts for a different operation
as follows:
WARNING
Disconnect primary power at the source before
assembling or disassembling torch parts, or torch
and leads assemblies.
NOTE!
The shield cup holds the tip and start cartridge
in place. Position the torch with the shield cup
facing upward to keep these parts from falling out
when the cup is removed.
1. If attached, remove the ohmic clip then
unscrew and remove the shield cup
assembly from the torch head. Wipe it
clean or replace if damaged
2. Remove the electrode by pulling it
straight out of the Torch Head.
Torch Head
Electrode
Start Cartridge
Shield Cup Body
Shield Cap
Automation Torch Parts
3. Install the replacement electrode by
pushing it straight into the torch head
until it clicks.
46
Art # A-04173_AB
Tip
Ohmic Clip
(If installed)
Deflector
TORCH OPERATION
4. Install the start cartridge and desired tip
for the operation into the torch head.
5. Hand tighten the shield cup assembly
until it is seated on the torch head. If
resistance is felt when installing the cup,
check the threads before proceeding
6. If used, attach the ohmic clip to the
shield cup.
4T.03 Machine and Hand Torch Parts Selection
The type of operation determines the torch parts
to be used.
Type of operation:
Drag cutting, standoff cutting or goug-
ing
Torch parts:
Shield Cup, Cutting Tip, Electrode and
Start Cartridge
NOTE!
Refer to Section "4T.03 Machine and Hand Torch
Parts Selection" and following for additional
information on torch parts.
Change the torch parts for a different operation
as follows:
WARNING
Disconnect primary power at the source before
assembling or disassembling torch parts, or torch
and leads assemblies.
NOTE!
The shield cup holds the tip and start cartridge
in place. Position the torch with the shield cup
facing upward to keep these parts from falling out
when the cup is removed.
1. Unscrew and remove the shield cup
assembly from the torch head.
2. Remove the electrode by pulling it
straight out of the Torch Head.
0700 402 229