Table of Contents
Advertisement
CUTMASTER 50+, CUTMASTER 70+
3.05
Work Lead Connections
Connect the Work Lead to the power supply and the work piece.
1.
Attach the Dinse type connection of the work lead to the power supply front panel as shown
below.
2.
Push in and turn clockwise to the right until tight.
3.
Connect the work clamp to the workpiece or cutting table. The area must be free from oil,
paint and rust. Connect only to the main part of the work piece; do not connect to the part
to be cut off.
See section 3T for torch installation.
32
INSTALLATION
0700 402 229
Advertisement
Table of Contents
