Table of Contents
Advertisement
section 6
6.7
mounting torch to machine
Refer to machine manual.
Warning
Mount torch on insulated sleeve here.
DO NOT mount
on steel torch
body here.
clamping on torch BoDY maY cause Dangerous current to
floW through machine chassis.
•
Do not mount on stainless steel torch body.
•
Torch body is electrically insulated, however high frequency
start current may arc through to find a ground.
•
Clamping near torch body may result in arcing between
body and machine.
•
When this arcing occurs, torch body may require non-war-
ranty replacement.
•
Damage to machine components may result.
•
Clamp only on insulated torch sleeve (directly above label)
not less than 1.25" (31.75 mm) from the torch end of the
sleeve.
•
PT-36 Torch has an outside diameter of 50mm for standard
mounting.
pt-36 plasma torch
60
Advertisement
Table of Contents
Troubleshooting
