Generator Recommendations Etl - ESAB CUTMASTER 50+ Operating Manual

2.09

Generator Recommendations ETL

When using generators to power the CM 50+ Plasma Cutting System, the following ratings are a
minimum and are to be used along with the ratings previously listed.
Generator Output Rating
NOTE: If Generator is equipped with an idle mode it will need to be in "Run" mode to operate at 50 amps.
When using generators to power the CM 70+ Plasma Cutting System, the following ratings are a
minimum and are to be used along with the ratings previously listed.
Generator Output Rating
NOTE: If Generator is equipped with an idle mode it will need to be in "Run" mode to operate at 70 amps.
Pierce Capacity
Standard Edge Cutting Capacity
Maximum Severance Cutting Capacity
Pierce Capacity
Standard Edge Cutting Capacity
Maximum Severance Cutting Capacity
NOTE!
Mild steel will typically have a larger cut thickness capacity because the material can also benefit from exothermic
reaction due to carbon content. Stainless steels, specialty hardened alloys, and non ferrous materials such as
aluminum and copper will generally have 20% or more lower cut capacity and slower cut speeds.
0700 402 229
CM 50+ Generator Specifications
10 kW / 480V
12 kW / 480V
CM 70+ Generator Specifications
10 kW / 480V
15 kW / 480V
20 kW / 480V
CM 50+ cut capacity
CM 70+ cut capacity
CUTMASTER 50+, CUTMASTER 70+
Output Current
40A
50A
Output Current
40A
60A
70A
Thickness
mm
16
25
32
Thickness
mm
20
30
38
INTRODUCTION
Arc Characteristic
Full
Full
Arc Characteristic
Full
Full
Full
inches
5/8
1
1 1/4
inches
3/4
1 1/8
1 1/2
21