Setting Panel - ESAB ET 180iP Instruction Manual

5 OPERATION
5.11

Setting panel

1. Button to change between direct current and
pulse current.
2. Display, shows set or measured value.
3. Button to select welding method: TIG HF,
LiftArc™ or MMA.
4. Set indicator.
5. Button to select 2-stroke or 4-stroke (TIG only).16. Button to change between the parameters in
6. Button to activate and deactivate remote
control unit.
7. Knob for setting data.
8. Gas pre flow indicator.
9. Slope up indicator.
10. Direct current or pulse current indicator.
11. Pulse balance.
0463 862 001
12. Background current indicator.
13. Pulse frequency indicator.
14. Slope down indicator.
15. Gas post flow indicator.
the graph.
17. Indicates which is shown in the display: s
(seconds for gas pre flow, gas post flow, slope
up and slope down), % (pulse balance), Hz
(pulse frequency).
18. Current set and measure value / Voltage
measure value.
19. Parameter selection button, selection indicated
by (18). Also used for access to hidden
functions.
20. Overheating indicator.
21. VRD function (reduced open-circuit voltage)
indicator.
- 20 - © ESAB AB 2023