Work Lead Connection - ESAB CIGWELD CutSkill 60 Operating Manual

3.05 Work Lead Connection

Connect the Work Lead to the power supply and the work piece.
1. Attach the male dinse plug of the work lead to the dinse socket on the front panel (refer to 2.04.4) as shown
in Figure 3-4. Push in and turn clockwise for a secure and sound electrical connection.
CAUTION
!
Loose terminal connections can cause overheating and result in the male plug being fused in the Dinse terminal.
2. Connect the work clamp to the work piece or cutting table. The working area must be free from oil, paint and
rust. Connect only to the main part of the work piece. Do Not connect to the part to be cut off.
CAUTION
!
Before connecting the work clamp to the work piece make sure the mains power supply is switched off.
0-5574
OPERATING MANUAL
Work Piece
Figure 3-4: Connecting Work Lead
3-5
CutSkill 60
Dinse Plug
Work Cable and Clamp
A-13685
INSTALLATION