Table of Contents
Advertisement
38 | DX-D 300 | Introduction
Messages
Messages are displayed on the NX workstation monitor, on the touch screen
console in the operator room or on the control panel.
Special messages are displayed in a dialog box in the middle of the screen or in
a fixed part of the screen. This message will tell that either a problem has
occurred or that a requested action cannot be performed.
The user must read these messages carefully. They will provide information on
what to do from then on. This will be either performing an action to resolve
the problem or to contact the Agfa service organization.
Details on the contents of messages can be found in the service
documentation which is available to Agfa service personnel.
Messages on the software console
Error codes indicate the potential cause of a system failure. Error codes are
shown on the software console. Correct the cause of the error and press the
"CONT." button until its indication disappears.
All these error codes will enable the operator to indirectly convey the possible
source of error to service personnel. This may prevent the need for a service
call or enable service personnel to anticipate corrective actions prior to
arriving on site.
Figure 14: Example of error code
0172G EN 20230627 1651
Advertisement
Table of Contents
