AGFA DX-D 300 User Manual page 117

interferences shown in General Regulation for safety according
to IEC 60601-1-2 tables as described in this section.
CAUTION:
The manufacturer is not responsible for any interference caused
by using other than recommended interconnect cables,
accessories and transducers or by unauthorized changes or
modifications to this equipment.
The DX-D 300 system is intended for use in the electromagnetic environment
specified below. The customer or the user of this DX-D 300 system should
assure that it is used in such an environment.
Table 15: Guidance and manufacturer's declaration on electromagnetic
emissions (IEC 60601-1-2)
Emission test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations / flick-
er emissions
IEC 61000-3-3
Note: In accordance with Standard IEC 61601-1-2, the emissions character-
istics of this equipment make it suitable for use in industrial areas and hospi-
tals (CISPR 11 Class A. If it is used in a residential environment (for which
CISPR 11 Class B is normally required) this equipment might not offer ade-
quate protection to radio-frequency communication services. The user might
need to take mitigation measures, such as relocating or re-orientating the
equipment.
The DX-D 300 system is intended for use in the electromagnetic environment
specified below. The customer or the user of this DX-D 300 system should
assure that it is used in such an environment.
DX-D 300 | Remarks for HF-emission and immunity | 117
Compli- Electromagnetic environment
ance
Group 1 The device uses RF energy only
for its internal function. There-
fore, its RF emissions are very
low and are not likely to cause
any interference in nearby elec-
tronic equipment.
Class A The device is suitable for use in
all establishments other than
domestic and those directly con-
nected to the public low-voltage
Class A
power supply network that sup-
plies buildings used for domes-
tic purposes.
Complies
- guidance
0172G EN 20230627 1651