98 | DX-D 300 | Operating the DX-D Software Console
Collimator Parameters
On systems with an automatic collimator, the collimation is automatically set,
based on the selected exposure.
To modify the automatic collimation, increase or decrease the collimator
parameters step by step, using the UP and DOWN arrows. The values increase
or decrease step by step each time the corresponding button is touched.
Figure 35: Collimator parameters
To use the same collimation setting on different exposures, push the store
button on the first exposure and push the restore button on all later exposures
that require the same collimation setting.
0172G EN 20230627 1651