Ricoh Pro C7500 Original Instructions Manual page 88

4. Image Quality Problem: Full Page
No
3. Is the toner fusibility within the permissible range?
• The required level of fusibility is as follows.
• The printed image does not come off.
• The toner does not come off even if it is lightly rubbed by a nail.
• The toner does not come off even if it is rubbed by the cloth for cleaning the contact
glass.
Yes
No
(b) Changing the fusing temperature (If [Print Speed] is set to [Low])
1. Select 1232: [Fusing Temperature], and then decrease the value in the following
corresponding settings by 20°C.
2. Set the value in the following corresponding settings to 0°C.
Productivity Priority
• 1232-02: Fusing Temperature: BW/FC/FCS: Correct Temp: Initial Feed
• 1232-10: Fusing Temperature: FCS: Correct Temp: Initial Feed: Clear/Special
• 1232-11: Fusing Temperature: FCS: Correct Temp: Initial Feed: White
• 1232-12: Fusing Temperature: FCS: Correct Temp: Initial Feed: Metallic
• 1232-30: Fusing Temperature: S: Correct Temp: Initial Feed: Clear/Special
• 1232-31: Fusing Temperature: S: Correct Temp: Initial Feed: White
• 1232-32: Fusing Temperature: S: Correct Temp: Initial Feed: Metallic
High Quality
• 1232-47: Fusing Temperature: BW/FC/FCS: Fuser Setting HQ: Correct Temp: Initial Feed
• 1232-55: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Initial Feed: Clear/
Special
• 1232-56: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Initial Feed: White
• 1232-57: Fusing Temperature: FCS: Fuser Setting HQ: Correct Temp: Initial Feed: Metallic
• 1232-75: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Initial Feed: Clear/Special
• 1232-76: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Initial Feed: White
• 1232-77: Fusing Temperature: S: Fuser Setting HQ: Correct Temp: Initial Feed: Metallic
86
Start over from Step 1.
Finished!
Change the print speed to "Low". Go to "(b) Changing the fusing temperature (If
[Print Speed] is set to [Low])".