Ricoh Pro C7500 Original Instructions Manual page 134

4. Image Quality Problem: Full Page
• 1232-53: Fusing Temperature: FCS: Fuser Setting HQ: Heat Roller Temp: Metallic
• 1232-71: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: Clear/Special
• 1232-72: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: White
• 1232-73: Fusing Temperature: S: Fuser Setting HQ: Heat Roller Temp: Metallic
3. Print on 10 or more sheets of A4 paper, short edge feed (SEF), to check if the image is
within the acceptable range.
Yes
No
4. Is the paper curled?
5. Check if the curl is within the acceptable range.
Yes
No
6. In [Detailed settings] for custom paper, select 1321: [Correct Paper Curl], and then
execute decurling.
To correct curls facing up, specify "U Curl Correction Level: Large" or "U Curl Correction Level:
Small".
To correct curls facing down, specify "П Curl Correction Level: Large" or "П Curl Correction Level:
Small".
7. Print the image. Has the problem been resolved?
Yes
No
• Select "Clear/Special" when using Neon Yellow, Neon Pink, or Invisible Red. Select "Metallic"
when using Gold or Silver.
• After performing the solution, it is recommended to perform the color calibration of the external
controller.
132
Go to the next step
Start over from Step 2.
If the print result exceeds the acceptable range even after increasing the heat roller
temperature to 185°C (at the standard/ medium print speed) or 200°C (at the low
print speed), there is no other solution.
Finished!
Go to the next step.
Finished!
Repeat Steps 6 and 7.
If the problem persists, there is no other solution.