Ricoh Pro C7500 Original Instructions Manual page 231

No Start over from Step 2.
If the problem persists even after decreasing the value to the lower limit, there is a
possibility of another cause. Since there is no other solution, restore the previous
settings.
(b) Scratches or Streaks on the Back of the Paper / Chattering Noise
1. If the paper is not registered as custom paper, register the brand of the paper.
2. In [Detailed settings] for custom paper, check the decurling level in 1321-01: [Correction
Mode].
3. In accordance with the decurling level, decrease the applicable setting's value by 0.5%.
If set to "Correction Off"
If set to "Correction
Weak"
If set to "Correction
Strong"
4. Print the image. Has the problem been resolved?
Yes Finished!
No Start over from Step 2.
If the problem persists even after decreasing the value to the lower limit, there is a
possibility of another cause. Since there is no other solution, restore the previous
settings.
(c) If the curl is not straightened
1. If the paper is not registered as custom paper, register the brand of the paper.
2. In [Detailed settings] for custom paper, check the decurling level in 1321-01: [Correction
Mode].
If set to "Decurler: Correction Strong", go to the next step.
If not, change the setting to "Decurler: Correction Strong", and then go to the next step.
3. Check if the curl is straightened.
Yes Finished!
No Go to the next step.
1321-02: Correct Paper Curl: Speed Adjustment: Decurler:
Correction Off
1321-03: Correct Paper Curl: Speed Adjustment: Decurler:
Correction Weak
1321-04: Correct Paper Curl: Speed Adjustment: Decurler:
Correction Strong
Streaks, Scratches, Disturbed Image, Crease
229