Ricoh Pro C7500 Original Instructions Manual page 102

4. Image Quality Problem: Full Page
Occurrence conditions:
• Printing is done at low temperature
• Paper with a thickness equivalent to Paper Weight 8 or higher is used
• Coated paper with a thickness equivalent to Paper Weight 5 or higher is used
• A solid image is printed
Solution:
1. In the [Machine: Productivity] group on the [Operator Adjust.] menu, select 0404:
[Pressure Roller Cooling Fan Level], and then set the value in the following settings to
[Strong].
• 0404-01: [Pre-Feed]
• 0404-02: [After-Feed]
• 0404-03: [On Standby]
2. Select 0403: [Fusing Temperature on Standby], and then set the value in the following
settings to "50".
• 0403-04: [Pressure Roller: On Standby]
• 0403-05: [Pressure Roller: On Panel Off]
• 0403-06: [Pressure Roller: On Low Power]
• 0403-07: [Pressure Roller: Before Process]
3. On the printer driver dialog box of Fiery Command WorkStation, set the fusibility
throughput setting to Fuser Setting HQ mode.
4. If the paper is not registered as custom paper, register the brand of the paper.
5. In [Detailed settings] for the custom paper you are using, select 1236: [Fusing Pressure
Roller Cooling], and then set the value in the following corresponding settings to "0".
• 1236-01: Fusing Pressure Roller Cooling: BW/FC/FCS: Fan Level: BW/FC/FCS
• 1236-02: Fusing Pressure Roller Cooling: FCS/S: Fan Level: Clear/Special
• 1236-03: Fusing Pressure Roller Cooling: FCS/S: Fan Level: White
• 1236-04: Fusing Pressure Roller Cooling: FCS/S: Fan Level: Metallic
6. Select 1233: [Fusing Pressure Temperature], and then set the value in the following
corresponding settings to "50".
• 1233-01: Fusing Pressure Temperature: BW/FC/FCS: Pressure Roller Temp: BW/FC/FCS
• 1233-02: Fusing Pressure Temperature: FCS/S: Pressure Roller Temp: Clear/Special
• 1233-03: Fusing Pressure Temperature: FCS/S: Pressure Roller Temp: White
• 1233-04: Fusing Pressure Temperature: FCS/S: Pressure Roller Temp: Metallic
100