Envelopes With Triangular Flaps Are Not Stacked Properly - Ricoh Pro C7500 Original Instructions Manual

Due to the Z-fold support tray, the contact position of the leading edge of the paper and exit tray
becomes farther, and the timing for the trailing edge of the paper to drop is delayed. If a side of the
jogger comes into contact with the delivered paper, the paper goes out of alignment in the direction of
the paper width, and the alignment accuracy is further worsened.
Solution:
Attach an Output banner sheet tray.
To attach an output tray for banner sheet, contact your service representative.

Envelopes with triangular flaps are not stacked properly

The trailing edge of a triangular flap envelope (center of the triangular flap) remains in the machine, so
the envelope is not stacked in the correct order or drops from the output tray.
Cause:
1. The trailing edge of the envelope is delivered by the paper exit roller to the exit tray, but the center
of the flap at the trailing edge is still prone to remain in the machine when the envelope has passed
the paper exit roller's nip.
120
190
175
[B]
[A]: Paper exit roller pitch
[B]: Paper feed direction
2. The center of the flap is humped, so the envelope fails to be flush against the end fence.
[A]
77.8
M0EDIC1360
Finisher/Booklet Finisher
297