Ricoh Pro C7500 Original Instructions Manual page 192

6. Image Quality Problem: Spots
Solution:
1. If the paper is not registered as custom paper, register the brand of the paper.
2. If the problem occurs only on Side 2 of the paper, go to Step 5.
If not, go to the next step.
3. In [Detailed settings] for custom paper, adjust the paper transfer output in 1214: [Paper
Transfer Output].
• 1214-01: Paper Transfer Output: BW: Side 1
• 1214-05: Paper Transfer Output: FC/FCS: Side 1
• 1214-09: Paper Transfer Output: FCS: Side 1
• 1214-13: Paper Transfer Output: S: Side 1: Clear/Special
• 1214-14: Paper Transfer Output: S: Side 1: White
• 1214-15: Paper Transfer Output: S: Side 1: Metallic
• In the case of toner blasting, increase the value by 2 steps.
• In the case of white spots, decrease the value by 2 steps.
4. Print the image. Has the problem been resolved?
Yes
No
• In the case of toner blasting, if the problem persists even after increasing the value to the
upper limit, there is no other solution.
• In the case of white spots, if the problem persists even after decreasing the value to the lower
limit, there is no other solution.
5. In [Detailed settings] for custom paper, adjust the paper transfer output in 1214: [Paper
Transfer Output].
• 1214-02: Paper Transfer Output: BW: Side 2
• 1214-06: Paper Transfer Output: FC/FCS: Side 2
• 1214-10: Paper Transfer Output: FCS: Side 2
• 1214-17: Paper Transfer Output: S: Side 2: Clear/Special
• 1214-18: Paper Transfer Output: S: Side 2: White
• 1214-19: Paper Transfer Output: S: Side 2: Metallic
190
If the problem occurs only on Side 1, this procedure is complete.
If the problem also occurs on Side 2, go to Step 5 to resolve the problem on Side 2.
Start over from Step 3.